If 
, then 
 is the point on the unit circle such that the length
of
the arc joining 
 to 
 (measured in the counterclockwise direction)
is
equal to 
. (There is an optical illusion
in the figure. The length of segment 
 is equal to the length of
arc 
.)
Remark:  The definition of 
 depends on several ideas that we have not
defined
or stated assumptions about, e.g., length of an arc and 
counterclockwise
direction.  I believe that the amount of work it takes to formalize these
ideas at this
point is not worth the effort, so I hope your geometrical intuition will carry
you
through this chapter. (In this chapter we will assume quite a bit
of Euclidean geometry, and a few properties of area that
do not follow from our assumptions stated in chapter 5.)
A more self contained treatment of the trigonometric functions can be found in [44, chapter 15], but the treatment given there uses ideas that we will consider later, (e.g. derivatives, inverse functions, the intermediate value theorem, and the fundamental theorem of calculus) in order to define the trigonometric functions.
We have the following values for 
:
In general
Since 
 is on the unit circle, we have
In equation (9.2) we defined
Proof:  From (9.10) we know
 in equation (9.16) we
get
 in this equation we get
 and get
In the process of proving the last theorem we proved the following:
Proof:  We have
In equation (9.24) replace 
 by 
 and replace 
 by
 to get
From the geometrical description of sine and cosine, it follows that as
 carries
the graph of sin onto the graph of cos, and vice versa.
The relation 
 shows that
We have
, so 
 and
(approximately).
With this information we can make a reasonable sketch of the graph of 
and 
(see the figure above)
Include an explanation for how you found 
 and
 (or 
 and 
).  For the
remaining values
you do not need to include an explanation.
Most of the material from this section
was discussed by Claudius Ptolemy (fl.
127-151
AD).  The functions considered by Ptolemy were not the sine and cosine, but the
chord, where the chord of an arc 
 is the length of the segment joining
its
endpoints.
 in intervals of 
The etymology of the word sine is rather curious[42, pp 615-616]. The function we call sine was first given a name by Aryabhata near the start of the sixth century AD. The name meant ``half chord'' and was later shortened to jya meaning ``chord''. The Hindu word was translated into Arabic as jîba, which was a meaningless word phonetically derived from jya, but (because the vowels in Arabic were not written) was written the same as jaib, which means bosom. When the Arabic was translated into Latin it became sinus. (Jaib means bosom, bay, or breast: sinus means bosom, bay or the fold of a toga around the breast.) The English word sine is derived from sinus phonetically.